drawing force

in a certain range. drawing force is reducing along with the increasing of drawing speed, which was reached by test.

通过试验得出拉拔力在一定范围内是随着拉拔速度的提高而降低的。

互联网摘选

The affect of the speed on the drawing force was obtained and the changing regular of the periodic of the tension regulator.

获得了拉丝速度对拉拔力的影响关系以及张力调节周期的变化规律。

互联网摘选

So the solution can be used to calculation of drawing force during draw-out by idle rolls.

因而，该解析解可在工程上计算圆管辊拔拔制力时推广应用。

互联网摘选

Calculation for Drawing Force of Aerial Cableway where Engine and Tension Apparatus Are Mounted in the Same Station House

驱动机与拉紧装置设在同一座站房的架空索道的牵引计算

互联网摘选

the additional drawing force for such processes is deducted respectively.

分别推导上述两个过程的附加拉坯力.

互联网摘选

Effect Factors on Drawing Force of Deforming Process of Spiral Rib Steel Wire and Finite Element Simulation

螺旋肋钢丝成肋时拉拔力影响因素及有限元分析

互联网摘选

the formula is therefore considered as available to the calculation of drawing force on tube sinking.

该计算式可用于圆管空拉拔制力计算.

互联网摘选

It also analyzed the tension increment requirement of steel wire while it was passing through the roll, and studied the influence of angle change on drawing force.

分析钢丝通过滚轮时张力增值的条件，研究包角变化对拉拔力的影响。

互联网摘选

The drive of technology, the drawing force of market demand, the coercive power of the government and the promote force of enterprise are four main driving forces for technical innovation. 2.

技术自身的推动力、市场需求的拉力、政府行为的强制力和企业内部的推动力是促使集群内企业进行技术创新的四个主要动力。

互联网摘选

Debase drawing force of T7 steel wire obviously and increase tensile strength, and increase specific elongation slightly;

显著降低T7钢丝的拉拔力，提高抗拉强度，并使其延伸率稍微增加；

互联网摘选

the drawing force, rational wall-thickness reduction and the characteristics of cold-draw process and equipment are analyzed.

分析了拔管时的拔制力 、 合理减壁率及冷拔工艺与设备特点.提出了全面控制工艺系统精度是提高产品质量的关键.

互联网摘选

when the roller passes through the roving, a certain twist level can be untwisted, and thereby the drawing force is reduced.

当粗纱须条在辊轮经过时能退去一定的捻度，使牵伸力降低。

互联网摘选

Experimental Research and Analysis of Welding Residual Stress of the Tensile Anchorage Region; Study on Drawing Force of Root Layer in Masonwork Affected by Anchor Bolt Type and Anchor Depth

斜拉桥锚拉板区域焊接残余应力试验研究分析锚栓类型、锚固深度对基层砌体拉拔力影响的研究

互联网摘选

Studies on drawing force of drawn tube with specially reduced thick wall

专减壁厚拔管拔制力的研究

互联网摘选

the factors influencing on total additional drawing force are discussed briefly.

讨论了影响各道次附加拉坯力的因素.

互联网摘选

under the same air flow, the side - lay's drawing force in the single - sheet feeding mode is stronger than in the stream feeding mode.

在同样气体流量前提下，间歇输纸的侧规拉纸力比连续输纸要大。

互联网摘选